Filter
Top Products
Installing the Batteries
Your ONE FOR ALL needs 2 new “AA/LR6” alkaline batteries.
1 Remove the battery cover from the back of your ONE FOR ALL by
p
ressing down on the tab.
2 Match the batteries to the + and - marks inside the battery case,
then insert the batteries.
3 Press the battery cover back into place.
See picture of ONE FOR ALL TV remote on page 3
1 LED
The LED (Light Emitting Diode) flashes red to show the remote is
working.
2 MAGIC Key
The MAGIC key is used to set up your ONE FOR ALL.
3 MENU Key
The MENU key controls the same function as it did on your original
remote.
4 POWER Key
The Power key controls the same function as it did on your original
remote.
5 Device Key
Pressing the TV key allows the remote to control the functions
of your Television.
6 Number Keys
The Number keys (0-9, 10, 20 (AV)) provide functions just like your
original remote, such as direct access programme selection. If your
original remote uses one/two digit input switching (-/-- symbol), this
function can be obtained by pressing the -/-- key, which is the same
as the 10 key. If your original remote has an 20 key, this function can
also be found under the AV key.
7 Programme (Channel) +/- Keys
These keys operate in the same way as the keys on your original
remote. If available on your original remote, these keys will allow
you to navigate through the menu.
The Keypad
Important notes:
-
In order to avoid having to reprogram your ONE FOR ALL after
you remove the batteries, you will need to insert new batteries
w
ithin 5 minutes. Also it is best that you do not use rechargable
batteries.
-
On the inside of the battery compartment door you will find a
label on which to write your Set-Up code after your ONE FOR ALL
i
s set up for your device. Please write down your code for easy,
future reference.
WWW.ONEFORALL.COM 4
705016_4515_S-10:ecoline 1_Rubber Scand 13-03-2007 00:44 Pagina 4