Filter
Top Products
9
8
7 Continue to enter your codes as
illustrated in Steps 5 and 6 until the
Home Producer is operating all of
your home entertainment
components. Once you have fin-
ished setting up your components,
press ESC to return to the [DEVICE
and TIME] display.
If you would like to set up each of your
components individually, or if you purchase a
component after you have set up the A/V Home
Producer, go to the “SETTING UP INDIVIDUAL
HOME ENTERTAINMENT COMPONENTS”
section on pages 10 to 23 in this manual.
Set Up Codes for TVs ...................................Page 10
Set Up Codes for VCRs ................................Page 13
Set Up Codes for TV/VCR Combinations .....Page 14
Set Up Codes for Cable Boxes .....................Page 16
Set Up Codes for DSS and
Satellite Receivers..................................Page 17
Set Up Codes for DVD or LD Players ...........Page 19
Set Up Codes for CD or MD Players ............Page 20
Set Up Codes for Tuner/Receivers................Page 22
Set Up Codes for Amplifiers......................... Page 23
QUICK SET-UP
To Quickly Set Up the Home Producer to
Operate Your Home Entertainment Components
NOTE: If the four-digit code for your device begins with a “0”, only
the last three numbers of your code will be displayed.
1 Turn on all of the components that
you will be setting up.
2 Press and release the TV key.
3 Press and hold SETUP until the
display screen changes from
[TV and the TIME] to [TIMED SEQ].
4 Press the MENU – key one time.
The display screen will change to
[CODE SETUP]. Press SELECT.
The display will change to
[DEV SET UP]. Press SELECT. The
display will change to [TV].
5 Enter the first TV code listed for your
brand in the “Set Up Codes for TVs”
on pages 10-12, then press
SELECT. Point the remote control at
the TV and press POWER.Your
Television should turn OFF. If your TV
does not turn OFF, enter the
next code in the code list then press
SELECT followed by POWER again.
Once your TV turns OFF, press VCR.
You will now enter your VCR code.
6 Enter the first VCR code listed for
your brand in the “Set Up Codes for
VCRs” on pages 13-14, then press
SELECT. Point the remote control at
the VCR and press POWER.Your
VCR should turn OFF. If your VCR
does not turn OFF, enter the next
code in the code list then press
SELECT followed by POWER again.
Once your VCR turns OFF, press
CBL/SAT. You will now enter your
Cable Box code.