Onkyo DPS-5.5 DVD Player User Manual


 
54
Using the Remote controller with Other Brand’s
TVs
Learning a pre-programming code
You can make RC-536DV remote controller to operate a
TV from other brand than Integra by storing the pre-pro-
gramming code of the brand in the RC-536DV.
Notes:
•With some brand’s components, some buttons may not
work correctly.
If more than one code is given in the table, try the code
one by one until you reach the code for your compo-
nent (i.e. if the first code does not work, then try the
next).
The code can be retained by changing the batteries
within 1 minute. If the code is lost, store the pre-pro-
gramming code again.
Controlling a TV
1
Find the 3-digit number for the
brand name of the component
that you want to operate in the
table on page 55.
2
Turn on the TV that you want to
operate.
3
While holding down the On/
Standby on the RC-536DV that
you want to program, press
Enter, and then release both but-
tons.
(Make sure you press On/Standby
before Enter.)
4
Within 10 seconds, enter the 3-
digit code number.
Volume
ChannelTV/Video
On/
Standby
TV Control
Clear
123
645
Repeat A
-
B
Random
Play Mode
Display
Dimmer
Menu
Setup
Top Menu
Return
Audio
Stop
Down Up
Play Pause
Angle Subtitle Zoom
RC
-
536DV
Open/
Close
On Standby
Enter
78
9
0
Enter
On/
Standby
///
TV Control
Numbers
Enter
On/
Standby
123
645
7
8
9
0
5
Press some operation buttons
for the component that you want
to operate to check if the system
operates properly.
If the system operates properly, the
code is correct. If the component does
not operate properly, return to step 2.
1
Press On/Standby to turn on the
device.
2
Press the desired operation but-
ton.
+ : Changes the TV channel
upward.
–:Changes the TV channel down-
ward.
: Increases the TV volume.
: Decrease the TV volume.
TV/Video : Switches the TV/VCR
inputs.
On/
Standby
TV/Video
Channel
Volume
DPS-5.5_En.book Page 54 Monday, May 17, 2004 4:45 PM