Onkyo DV-CP702 DVD Player User Manual


 
15
Before Using the DV-CP702
Notes:
The supplied batteries should last for about six months,
although this will vary with usage.
If the remote controller doesn’t work reliably, try replacing
both batteries.
Don’t mix new and old batteries, or different types of bat-
teries.
If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage and
corrosion.
Flat batteries should be removed as soon as possible to pre-
vent possible leakage and corrosion.
To use the remote controller, point it at the DV-CP702’s
remote control sensor, as shown below.
Notes:
The remote controller may not work reliably if the DV-
CP702 is subjected to bright light, such as direct sunlight
or inverter-type fluorescent lights. Keep this in mind when
installing the DV-CP702.
If another remote controller of the same type is used in the
same room, or the DV-CP702 is installed close to equip-
ment that uses infrared rays, the remote controller may not
work reliably.
Don’t put anything, such as a book, on the remote control-
ler, because the buttons may be pressed inadvertently,
thereby draining the batteries.
The remote controller may not work reliably if the DV-
CP702 is installed in a rack behind colored glass doors.
Keep this in mind when installing the DV-CP702.
The remote controller will not work if there’s an obstacle
between it and the DV-CP702’s remote control sensor.
Installing the Remote Controller’s
Batteries
1
Open the battery compartment, as shown.
2
Insert the two supplied batteries (AA) in
accordance with the polarity diagram inside
the battery compartment.
3
Close the battery compartment.
Using the Remote Controller
30˚
30˚
DV-CP702
Remote control sensor
Approx. 16 ft. (5 m)
✱✽-✰✷✪✣✥ ✱✽✱✰❉❂n❈❆❍ ✷❂❈❆ ✤★ ✻❑❆■❅❂❖, ✳❆❃❍❑❂❍❖✤✣, ✥✣✣✧ ✤✣:✤✥ ✮M