Onkyo DV-CP702 DVD Player User Manual


 
46
Troubleshooting
—Continued
Symptom Possible cause Remedy
The message “NO
PLAY” appears on the
display?
The disc is dirty. Remove the disc and clean it (page 8).
Buttons on the DV-
CP702 and remote con-
troller don’t work?
Power supply voltage fluctuations and other
anomalies, such as static electricity, can
interfere with normal operation.
Turn off the DV-CP702, wait five seconds, then
turn it on again. If that doesn’t resolve the issue,
disconnect the power cord from the wall outlet,
wait five seconds, reconnect it, then try again.
Buttons on the DV-
CP702 work OK but
those on the remote con-
troller don’t?
There are no batteries in the remote
controller.
Install new batteries (page 15).
The batteries are flat. Replace with new batteries (page 15).
The batteries are installed incorrectly.
Check the batteries and correct as necessary
(page 15).
You’re not pointing the remote controller at
the DV-CP702’s remote sensor.
Point the remote controller at the DV-CP702’s
remote sensor (page 15).
You’re too far away from the DV-CP702.
Use the remote controller closer to the DV-CP702
(page 15). The remote controller has a range of
approximately 16 ft. (5 meters).
A strong light source is interfering with the
DV-CP702’s remote sensor.
Make sure that the DV-CP702 is not subjected to
direct sunshine or inverter-type fluorescent lights.
Relocate if necessary.
If the DV-CP702 is installed in a cabinet
with colored glass doors, the remote control-
ler may not work reliably when the doors are
closed.
Open the doors, or use a cabinet without colored
glass.
Abnormal Behavior
The DV-CP702 contains a microcomputer for signal processing and control functions. In very rare situations, severe interfer-
ence, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this should happen,
unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again. Alternatively, press and
hold the STOP [ ] button until “RESET” appears on the display (about 10 seconds).
Restoring the Default Settings
To reset the DV-CP702 to its factory defaults, turn it on and, while holding down the STOP [ ] button, press the [STANDBY/
ON] button. “INITIALIZE” appears on the display. When the reset is complete, “COMPLETE” is displayed, and the DV-
CP702 enters Standby mode.
✱✽-✰✷✪✣✥ ✱✽✱✰❉❂n❈❆❍ ✷❂❈❆ ✧✩ ✻❑❆■❅❂❖, ✳❆❃❍❑❂❍❖✤✣, ✥✣✣✧ ✤✣:✤✥ ✮M