Onkyo DV-SP301 DVD Player User Manual


 
17
Turning on
The DV-SP301 is shipped with the main power (POWER) switch
in the on position (_ON). When the power cord is plugged in for
the first time, the DV-SP301 will automatically enter the standby
mode and the STANDBY indicator will light (same condition after
step 2 below).
Notes
Make sure that all appropriate connections have been completed
as described on page 13 to 16.
Turning on the DVD Player may cause a momentary power
surge, which might interfere with other electrical equipment
such as computers. To prevent interference, use a wall outlet on
a different circuit.
1 Plug the power cord into the power outlet on
the wall.
2 Press POWER to switch on the main power.
The DVD Player enters standby mode.
The STANDBY indicator lights up.
Notes
The buttons on the remote controller do not operate if the
POWER switch is set to OFF.
To switch off the main power, press POWER again.
The system remains in standby mode for 5 seconds after
the power is turned on.
3 Press STANDBY/ON on the DVD Player or
remote controller.
The DVD Player turns on and the STANDBY indicator
turns off. It takes several seconds to read the disc in the disc
tray.
Notes
You can turn on the DVD Player by pressing OPEN/
CLOSE 0 or PLAY/PAUSE £/8.
To put the DVD Player in the standby mode, press
STANDBY/ON on the DVD Player, or remote
controller.
While the STANDBY indicator lights up, the DVD Player
can receive signals from the remote controller. However,
if you press POWER on the DVD Player to switch off the
main power, the remote controller cannot be used to turn
on the DVD Player.
Setting the STANDBY/ON button to standby does not
shut off the power completely.
Connecting the POWER
POWER STANDBY/ON
STANDBY indicator
STANDBY/ON