Filter
Top Products
16
When you set
DST
to
ON
, the VCR auto-
matically adds 1 hour on the first Sunday in
April, and subtracts 1 hour on the last Sun-
day in October.
8. Press .
SET
COMPLETED
appears.
9. Review the information you entered.
If the information is not correct, repeatedly
press
(marked to the left of
REW
on the
remote control) or to move the cursor
to the incorrect entry, then enter the correct
information.
When the information is correct and the
time reaches the minute you set in Step 6,
press
MENU/ACTION
twice. The currently
set time appears and the clock starts run-
ning.
Note:
Seconds begin counting from 00
when you press
MENU/ACTION
twice.
Turning On Auto Clock Set
If you turned off the auto clock set feature and
manually set the VCR’s clock, then find that
EDS is available in your area, you can turn the
auto clock set feature back on. This ensures
that the VCR automatically sets itself to the
correct time after a power failure of less than
24 hours.
Follow these steps to turn on auto clock set.
1. Press
MENU/ACTION
to display the main
menu.
2. Repeatedly press or to highlight
SET
CLOCK
, then press .
3. If necessary, press or to highlight
AUTO
CLOCK
SET
, then press .
4. Press
CH
s
. The VCR searches for an EDS
signal and, if it finds one, automatically
sets its clock to the correct time. If the VCR
does not find an EDS signal, follow the
steps under “Manually Setting the Clock”
on Page 15.
Adding/Erasing Channels
We recommend you check the channels the
VCR automatically stored. It might have stored
distant, weak channels that you normally would
not watch, or it might have missed channels
you want to store.
If the tuner stores a channel that you do not
want, repeatedly press (or hold down)
CH
s or t
or use the remote control’s number buttons to
tune to that channel, then press
ADD/DLT
.
CHANNEL
nn
DELETED
appears, and the un-
wanted channel is erased from the tuner’s
memory.
To add a channel, enter the desired channel
number using the number buttons. Then press
ADD/DLT
.
CHANNEL
nn
ADDED
appears, and
the channel is added to memory.
Reprogramming Tuner Memory
You might want to reprogram the VCR’s tuner
memory if you move or change from an anten-
na connection to a cable TV connection.
Note:
You can also quickly erase all settings,
including the time, local channels, and pro-
grammed events, then reprogram the tuner’s
memory. See “Resetting the VCR’s Memory”
on Page 18.
Follow these steps to reprogram the tuner.
1. Press
MENU/ACTION
to display the main
menu.
Note:
To exit the programming mode dur-
ing Steps 2–5, press
MENU/ACTION
again.
2. Repeatedly press or to highlight
SET
UP
CHANNEL
, then press .
KEY
D
ST
:
ON
12
:
0
0
P
M
-
--
-
-
-
-
-
K
-
-
-
-
-
-
16-634.fm Page 16 Tuesday, July 20, 1999 5:37 PM