Filter
Top Products
9
INSTALLATION
BASIC CONNECTIONS
Refer to the illustrations on Page 10 for these
connections.
Note:
Some connections shown in this section
might require additional supplies, available
from your local RadioShack store.
þ
Connect the VCR to
y
our TV for
pla
y
back. You can connect (choose
one):
• Your VCR’s
OUT TO TV
jack to your
TV’s antenna jack, using a 75-ohm
coaxial cable
Caution:
Never connect the VCR’s
OUT TO TV
jack to a terminal that has
an antenna already connected. Doing
so can interfere with other receivers.
• Your VCR’s
OUT TO TV
jack to your
TV’s separate VHF/UHF antenna
jacks, using a 75-ohm coaxial cable
and a VHF/UHF splitter/combiner
• Your VCR’s
R-AUDIO-L/VIDEO OUT
jacks to your TV’s audio/video jacks,
using a stereo audio/video cable
Note:
For the best quality recordings,
use high-quality A/V cables to make
these connections.
À
Connect a si
g
nal source to the VCR
for recordin
g
. You can connect
(choose one):
• An outside antenna, using a 75-ohm
coaxial cable, to the VCR’s
IN FROM
ANT.
jack
• An outside antenna, using 300-ohm
lead-in wire and a 300-to-75 ohm
transformer, to the VCR’s
IN FROM
ANT.
jack
• Your CATV (cable) source, using the
75-ohm coaxial cable directly from
the cable company, to the VCR’s
IN
FROM ANT.
jack
Caution:
Some state laws restrict
direct connections to cable wires
(connections that do not go through a
cable box). Check the laws in your
area before you make connections.
• A cable converter box to the VCR’s
IN
FROM ANT.
jack
Note:
There are many cable TV sys-
tems in use. If you subscribe to cable
TV service and cannot record cable TV
programs, contact your local cable TV
service provider. Most cable TV service
providers offer connection help.
Ã
You can also connect an optional
video source, such as a camcorder,
another VCR, or a direct-to-home
satellite s
y
stem to
y
our VCR usin
g
A/V cables. Simpl
y
connect it as
shown.
Connection Notes:
• You can connect three sources directly to
your VCR. To do so, you connect one source
to the
R-AUDIO-L IN 1/VIDEO IN 1
jacks on
the back of the VCR using A/V cables,
another source to the
IN FROM ANT.
jack
using a 75-ohm coaxial cable, and another
source to the
AV2 VIDEO IN/L-AUDIO IN-R
jacks on the front of the VCR (see “Cam-
corder Connections” on Page 12). If the
source’s audio is monaural, connect its audio
output to the left audio input jack only.
• You can connect additional 75-ohm
coaxial sources to your system using a
high-isolation A/B switch to switch
between the sources.
• You can connect one 75-ohm coaxial
source to more than one device using a
video splitter.
Because of the complexity of the variations
possible when using additional video accesso-
ries, such as video signal switches, splitters,
and combiners, we do not attempt to show
such configurations in this manual.
16-634.fm Page 9 Tuesday, July 20, 1999 5:37 PM