Sylvania 6620 LDF TV VCR Combo User Manual


 
- 15 - EN
You can view specially labeled (cc) TV programs,
movies, news and pre-recorded tapes with either a
dialogue caption or text display.
CAPTION mode: You can watch dramas, movies and
news while captioning the dialogues and the contents
of news.
TEXT mode: You can watch half screen text informa-
tion if you want.
1-2: You may get these captions or text information
by selecting either “1” or “2”. Caption “2” is usually
used for a second language if available.
Not all programs are broadcast with closed cap-
tions. Your unit is designed to provide error free
closed captions from high quality antenna, cable
and VCR signals. Conversely, poor quality sig-
nals are likely to result in caption errors or no
captions at all. Common signal conditions which
may cause caption errors are listed below:
Automobile ignition noise
Electric motor brush noise
Weak snowy reception on TV screen
Multiplex signal reception displaying picture
ghosts or airplane flutter
If the unit displays a black box on the TV
screen, this means that the unit is set to the
TEXT mode. To clear screen, select “CAP-
TION1”, “CAPTION2” or “OFF”.
1 Press [SETUP] then press [K] or [L] to point
to “CAPTION”.
2 Press [ENTER] repeatedly to select the
desired caption menu “CAPTION1”, “CAP-
TION2”, “TEXT1” or “TEXT2”.
If you select “OFF”, Closed Caption System set-
ting is cancelled.
3 Press [SETUP] to exit the menu.
Even if there is a power failure of any
kind, the unit will retain its memory for
this feature.
TO SELECT TV SOUND MODE
1 Press [AUDIO] repeatedly to select the MTS
output mode.
The output mode changes as described below
every time you press [AUDIO].
* Second Audio Program (SAP):
Sometimes broadcasters add another channel of
audio to the programs they air. This is usually a
secondary language or perhaps a radio station.
After 5 seconds, the current audio status will
disappear from the TV screen.
The initial setting is “STEREO”.
This setting is saved even if the unit is turned
off or the AC cord is unplugged.
TO CHECK THE SOUND STATUS
By pressing [DISPLAY], the status shown below
will appear on the display when you receive a broad-
cast on the unit tuner channel you are watching.
1) When a program is broadcast in stereo,
“STEREO” appears on the TV screen.
2) When a program is broadcast in second audio,
“SAP” appears on the TV screen.
3) When a program broadcast both in stereo and sec-
ond audio, “STEREO/SAP” appears on the TV
screen.
CLOSED CAPTION SYSTEM
- TV SET UP -
CHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
B CAPTION [OFF]
BACK LIGHT [BRIGHT]
- TV SET UP -
CHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
B CAPTION [CAPTION1]
BACK LIGHT [BRIGHT]
SETUP
ENTER
SETUP
MTS (Multi-Channel Television
Sound) System
AUDIO
NOTE
NOTE
STEREO
SAP
*
MONO
NOTE
TV SECTION
TV OPERATION AND SETTINGS
STEREO
CH 123
STEREO/SAP
3)
1)
2)