Filter
Top Products
14
WATCHING TV
Sleep Timer
can set the unit to go into standby mode after an incremental period of time.
Press SLEEP repeatedly to change the amount of time (increases
the time by 30 minutes up to 120 minutes).
Sleep 120min.
Press SLEEP once to call up the display for checking the remaining time.
• To cancel sleep timer, press SLEEP repeatedly until [Sleep Off] is
displayed.
Switching Each Input Mode can easily switch with the remote control
between TV (ATSC or NTSC) and external devices when they are connected to the unit.
Press INPUT SELECT or CH ▲ repeatedly to cycle through the input modes.
TV
HDMI1
HDMI2
Component
Video
TV
Video
Component
HDMI1
HDMI2
Input Select
e.g.)
Video Component
11-1
DTV / TV channel
HDMI2 HDMI1
(or PC input)
• Pressing CH ▼ reverses the direction of the input modes.
Channel Selection
Select channels by using CH ▲/▼ or the Number buttons.
• To select the memorized channels,
use CH ▲/▼ or the Number buttons.
• To select the non-memorized channels,
use the Number buttons.
11-1
To use the Number buttons
AT SC
- When selecting digital channel 11−1
Be sure to press − before entering the subchannel number.
NTSC
- When selecting cable or analog channel 11
Press CH RETURN to return to the previously viewed channel.
Note
• [No Signal] will appear on the TV screen after the subchannel
broadcast is over.
• [Audio only program] message will appear on the TV screen, when you
receive only sound signal.
Still Mode can freeze the image shown on the TV screen for 5 minutes.
Press PAUSE
F
to freeze the image.
Still
• The sound output will not be paused.
• To cancel freeze mode, press any buttons except POWER.