i
ENGLISH
Preface
About this Manual
This manual is designed to assist you in setting up and using your LCD display. Information
in this document has been carefully checked for accuracy; however, no guarantee is given to
the correctness of the contents. The information in this document is subject to change without
notice. This document contains proprietary information protected by copyright. All rights are
reserved. No part of this manual may be reproduced by any mechanical, electronic or other
means, in any form, without prior written permission of the manufacturer.
Copyright
Copyright 2003. All Rights Reserved.
Trademarks
VESA is a registered trademark of the Video Electronics Standards Association. DPMS and
DDC are trademarks of VESA.
ENERGY STAR
®
is a registered trademark of the U.S. Environmental Protection Agency.
As an
ENERGY STAR
®
partner, the manufacturer has determined that this product meets
theENERGY STAR
®
guidelines for energy efficiency.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digi-
tal device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communications. How-
ever, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
Caution: To comply with the limits for an FCC Class B computing device, always use the sig-
nal cord and power cord supplied with this unit. The Federal Communications Commission
warns that changes or modifications to the unit not expressly approved by the party responsi-
ble for compliance could void the user’s authority to operate the equipment.