Filter
Top Products
Menu item select
Tuning In
12
Manual Search
If auto search can not preset the desired channels, or you
want to preset the desired channels one by one with the
preferred channel numbers, please make use of Manual
Search.
3.1 From the PRESET menu, press
CH+/- to select PROGRAM item
and use VOL+/- to select a
program number.
Note: You can also use 0-9 button to input the channel
number directly.
3.2 Press CH+/- to select
MANUAL SEARCH item. Press
and hold VOL+ to search towards
higher frequency; or press and hold
VOL- to search toward lower
frequency. When a channel is
located, the searching stops and
the channel is stored in the
specified channel number.
You can also use BAND selection
to quicken searching process if you
know which band your desired
program locates in. Press CH+/- to
select BAND item, press VOL+/- to
adjust. The band switches among
UHF, V-L, V-H.
3.3 Repeat step 3.1 and 3.2 if you want to store another
program in other position number.
After you finish searching, you may press DSP or
repeatedly press MENU button to exit.
3
PROGRAM
SKIP
BAND
FINE TUNE
MANUAL SEARCH
AUTO SEARCH
CH.SWAP
CH TYPE
001
OFF
V-L
- - -
NEWS
SET
SEL.
PROGRAM
SKIP
BAND
FINE TUNE
MANUAL SEARCH
AUTO SEARCH
CH.SWAP
CH TYPE
001
OFF
V-L
- - -
NEWS
SET
SEL.
PROGRAM
SKIP
BAND
FINE TUNE
MANUAL SEARCH
AUTO SEARCH
CH.SWAP
CH TYPE
001
OFF
V-L
- - -
NEWS
SET
SEL.
Direct Channel
select
Menu item select
Menu item select
To exit
menu
To display
menu page