Palsonic HDSTB100 DVR User Manual


 
SET-UP AND QUICK USE GUIDE
1
Step 1: Connect AC Power Cord
Plug the AC power cord into the AC outlet. Do not turn on any devices until you
have finished making all necessary connections.
Step 2: Antenna Connection
Connect the antenna cable to the RF IN jack on the rear panel of the STB (For
details, please refer to page 8).
Step 3: Connecting to Monitor
A.
If your monitor is an Analog Monitor, please follow the diagram and notes
in page 9 when connecting the STB to your monitor.
B. If your monitor is a HD Monitor (YPbPr type), please follow the diagram
and notes in page 10 when connecting the STB to your monitor.
C. If your monitor is a HD Monitor (RGB type), please follow the diagram
and notes in page 11 when connecting the STB to your monitor.
Step 4: Connecting to a Secondary Display or VCR
Please follow the diagram and notes in page 12 when connecting the STB to the
Secondary Display or VCR.
Step 5: Connecting to an Amplifier
Please follow the diagram and notes in page 12 when connecting the STB to the
Amplifier.
Step 6: Turning STB On
Press the Power Switch on the STB to turn on the STB.
Note: Monitor should also be turned on.
Step 7: Setting Time Zone
To obtain local time, you should first set local time zone. For further details, please
refer to page 18.