Filter
Top Products
Chapter 2: Introduction
4
Remote control function key list
Remote control battery installation
Detach the battery cover on the rear of the
remote control, and insert two size AAA
batteries in correct polarity.
Caution
Do not mix old and new batteries. Never
mix different types of batteries (standard,
alkaline, etc.).
Remote Control Operation Range
Point the remote control at the remote
sensor and press the buttons.
Distance: About 5 m from the front of
the remote sensor.
Angle: About 300 in each direction of
the front of the remote sensor.
You can operate every function of this STB using the buttons
on the remote control handset. Below is the remote control
functional key list.
Press to turn ON and OFF (in standby).
Press to mute the sound. Press again to restore.
Press numeric keypad to select any channel.
In menu operation, used to enter numerical values
wherever required, e.g. to enter a password.
You can quickly check the status of current display
program by pressing the DSP button.
Press DSP button twice to display EPG information if
available.
You can choose different audio outputs in Audio
Setup menu. The STB includes standard audio mode
options such as stereo or mono sound to match the
broadcast signal or your home entertainment stereo
system. Other audio mode options may be supported
by your service provider or TV broadcaster, such as
selecting alternate languages, or different
commentators for sport events.
Press AUDIO button, then make use of menu
navigation button ( , ) and ENTER button to
select.
AUDIO
VOLUME +/-
Press to increase or decrease the volume.
PROGRAM+/-
Select next/previous programs.
LIST
When you are watching TV channels, you can press
LIST button to call up the Program List.
MIX
Press to conceal or reveal main picture and (or) PIP
when viewing teletext.
TELETEXT
Press to display teletext on the screen if available.
Note: normally it will display teletext index page
P100 when pressing TTX button. If TV station does
not broadcast teletext information but caption, the
unit will switch to Page 801 to display Caption after
15 seconds.
If you are sure that there is no index page, you can
directly enter into page 801 to save time. Whether
there is index page or not, you can consult local
station.
DSP
0 ~ 9