Filter
Top Products
21
MULTI PIP
Selecting the Target Screen for Operations
Each time this button is pressed, the target screen for operations changes.
PC
INPUT1
PC
INPUT1
Main screen Sub screen
Main screen input mode Sub screen input mode
Operations on
the main screen
Operations on
the sub screen
Notes:
• When operations are performed for the sub screen, the sub screen audio is played.
• If no operations are performed, the operation target returns to the main screen after about 5 seconds*.
You can also return to main screen operations by operating the remote control buttons (except for ).
* It takes more than 5 seconds if a slot mounted with a Dual HDMI Terminal Board (TY-FB10HMD) is selected.
Selecting the Sub Screen Position (During P IN P Display)
Each time this button is pressed, the sub screen position changes.
Note:
Some sub screen positions may hide the display of the menu screen.
Notes:
• Do not use the two-screen display for a long time. It will cause a permanent image retention to remain on the screen.
• If “INPUT lock” in Options menu is set to other than “Off”, MULTI PIP function isn’t available.
• Sound output is from the picture which is selected in AUDIO OUT (PIP) (see page 35).
• In two-screen display, the same input mode cannot be selected for the main picture and sub picture.
• The main picture and sub picture are processed by different circuits, resulting in a slight difference in the clarity of the
pictures. There may also be a difference in the picture quality of the sub picture depending on the type of signals displayed
on the main picture and depending on the two-screen display mode.
• Due to the small dimensions of the sub pictures, these sub pictures cannot be shown in detail.
•
Computer screen picture is displayed in a simplifi ed format, and it may not be possible to discern details on them satisfactorily.
•
Following combinations of two analog signals cannot be displayed simultaneously;
Component - Component, Component - PC (RGB), PC (RGB) - Component, PC (RGB) - PC (RGB)
•
2k1k signals that are received with the Dual Link HD-SDI Terminal Board (TY-FB11DHD) cannot be displayed in two-screen
display.