Filter
Top Products
– 111 –
INSERT/ASSEMBLE AUTO EDIT menu
(2) Search the edit point using the search dial.
1) Search the edit point using the search dial.
2) Press the ENTRY button.
≥Trimming operations
(1) Press the center cursor key.
The cursor now appears.
(2) Press the cursor key to move the cursor to the section with the data to be trimmed.
(3) Set the F7 (TRIM) key to ON.
(4) Press the center cursor key again so that the cursor is made to serve as a column cursor.
(5) Press the “i” or “j” button to trim the edit point in 1-frame increments.
Each time the “i” button is pressed, the point is incremented by
1 frame.
If the “i” button is held down, the point is incremented continu-
ously.
(6) Press the F7 (TRIM) key to set it to OFF.
ONotesN
When the edit points are entered during editing with the player or editor (recorder), the final (fourth) edit point
is automatically calculated from the other edit points and entered as a virtual edit point.
≥The “¢” mark appears at the side of a virtual edit point display.
≥If a virtual edit point is to be cleared, it will be cleared automatically by clearing the other edit points.
Center cursor key
Cursor key
IN
R
00:00:02:14
ON
TRIM
OFF
TRIM
IN
R
00:00:02:16