Filter
Top Products
– 13 –
TC/CHR CONVERT menu
This menu is displayed by pressing the following keys: ) When the center cursor key is
pressed, the 24TC display is highlighted. To enter the time code, use the number keys and cursor keys
(2, 1) to set the time code, and then press the key. Move on to the 30TC/25TC value setting using the
cursor keys (3, 4), and proceed in the same way to set and enter the time code.
ENT
F9TC/CHR
F13
F12
F11
F10
F9
F8F7F6F5F4F3F2F1
Key
F1–F2
F3
F4
F5
F6–F7
F8
F9
F10
F11
F12
F13
Key designation
——
SYNC PHASE°
——
DF MD°
——
EXIT
——
RC_TC°
SD SUPER
HD SUPER
LTC OUT°
Description
For setting the reference for the 3:2 conversion sequence.
A: Frame A is used as the reference to convert the time code.
B: Frame B is used as the reference to convert the time code.
C: Frame C is used as the reference to convert the time code.
D: Frame D is used as the reference to convert the time code.
For selecting whether the 3:2 pull-down output from the 1080/23psf
(p) or 1080/24psf (p) format after it is converted into the time code
and output is to be in the drop frame or non-drop frame mode.
DF: The output will be in the drop frame mode.
NDF: The output will be in the non-drop frame mode.
Returns the VTR to the TC/CHR menu screen.
For selecting the time code which is to be output to the remote
connectors (RS-422, etc.).
24TC: The original time code with the frame count of 24 is output.
30TC: The post-conversion time code with the frame count of 30
is output.
For selecting the time code which is to be output to the SD monitor connector.
24TC: The original time code with the frame count of 24 is output.
30TC/(25TC): The post-conversion time code with the frame
count of 30/(25) is output.
For selecting the time code which is to be output to the HD monitor
connector.
24TC: The original time code with the frame count of 24 is output.
30TC/(25TC): The post-conversion time code with the frame
count of 30/(25) is output.
For selecting the time code which is to be output to the LTC output connector.
24TC: The original time code with the frame count of 24 is output.
30TC: The post-conversion time code with the frame count of 30
is output.
°This is not displayed with the 50i/25psf (p).