Filter
Top Products
15
Operating procedure
Sub carrier phase adjustment
1 Select the first camera to be adjusted by pressing the CAM CONTROL button.
2 Press the MENU button to display the menu on the LCD panel.
3 Turn the CONT dial to display the G/L SETTING menu.
4 Push the CONT dial straight down twice to display SC COARSE on the bottom line of the LCD. The sub carrier phase can
now be adjusted coarsely by turning the CONT dial.
When the CONT dial is pushed three times, SC FINE appears, and the sub carrier phase can now be adjusted finely by
turning the CONT dial.
5 Keep adjusting the SC COARSE and SC FINE phase so that the sub carrier (color) phase of the video signal output is
aligned with the colors of the program output (split color bar output) of the video switcher or other unit that serves as the
reference.
The color phase can be adjusted more accurately if a vectorscope is used.
6 Select the next camera by pressing the CAM CONTROL button, and adjust the sub carrier phase of the next camera.
Repeat this for all the connected cameras.
$ Video adjustment of cameras
This adjustment is performed when the pedestal of a multiple number of cameras is to be brought into alignment.
1 Select the first camera to be adjusted by pressing the CAM CONTROL button.
2 Set the lens iris to manual, and stop it down.
3 Use an oscilloscope or waveform monitor to adjust the pedestal level to correspond to the reference level using the total
pedestal dial.
4 Select the next camera by pressing the CAM CONTROL button, and adjust the pedestal of the next camera. Repeat this
for all the connected cameras.
White
Yellow
Cyan
Green
Magenta
Red
Blue
Black
Color bars of camera
Split line
Color bars of special
effects unit
Adjust the pedestal level
to the reference level.