Filter
Top Products
9
K CONTROL OUT TO CONTROL PANEL
connector
When connecting the pan/tilt control panel for operation,
connect this connector to the CAMERA CONTROL IN
FROM ROP connector on the pan/tilt control panel using
the control panel’s connecting cable. The cameras are
then controlled through the pan/tilt control panel.
L TALLY/INCOM connector
Connect this to the TALLY/INCOM connector on the
video switcher or other units.
When the TALLY connector is set to the GND level, the
(1) TALLY lamp lights. Do not apply a voltage in excess
of 5V to this connector.
Use the accessory tally/INCOM connector (D-SUB 15-pin)
to connect the tally/INCOM signals to the system.
Connect a 4-wire INCOM system to the INCOM
connector.
When the ROP has been connected to the pan/tilt control
panel, the tally/INCOM functions of the ROP and the
pan/tilt control panel will be executed if the tally/INCOM
signals are connected to the ROP or the pan/tilt control
panel.
M
CONTROL OUT TO CAMERA connectors [1] to [5]
Connect these to the convertible cameras.
Use the connecting cables (optional accessory)
AW-CA50T8 or AW-CA50T9 + RS-422/RS-232C
converter to connect these connectors to the I/F
REMOTE connectors on the convertible cameras.
N DC 12V IN socket
Connect the AW-PS505 AC adaptor (optional accessory)
to this socket.
When the ROP is connected to the pan/tilt control panel
using the pan/tilt control panel connecting cable, power
will be supplied to the ROP from the pan/tilt control panel.
O Grounding terminal
Connect this terminal to ground.
KL
M
N
O
$ Rear panel
Pin No. Signal Name
1 TALLY1
9 TALLY2
2 TALLY3
10 TALLY4
3 TALLY5
11 TALLY GND
4 – – –
12 – – –
5 – – –
13 – – –
6 MIC +
14 MIC –
7 INCOM GND
15 SP –
8 SP +
87654321
?>=<;:9
Pin layout as seen from the
back panel of AW-CB400
Parts and their function