Panasonic BT-LH900E Flat Panel Television User Manual


 
23
Error and warning displays
If an error has occurred in the monitor for some reason, an error or warning display will appear on the screen.
± CRCC error
When this error appears
When the SDI signals contain an error, the CRCC error display appears on the screen.
When a menu is displayed, the error is indicated in the menu area. At all other times, it is indicated on the status
display. However, only the error will be displayed when 3SEC OFF or OFF has been selected as the STATUS
DISPLAY item setting on the OSD screen. On the other hand, if OFF has been selected as the CRCC MESSAGE
item setting on the OSD screen, the error will not be displayed even when it has been detected.
Countermeasure
Check the input signals and connection statuses.
± Inverter error
When this error appears
If trouble has occurred in the inverter which controls the brightness of the backlight, the backlight is turned off, and all
the lamps by the sides of the image controls and tally lamps flash at 1-second intervals.
Countermeasure
Turn off the power and turn it back on. If the error display persists, contact a Panasonic Service Centre.
± Low remaining battery charge warning/error
When this warning/error appears
If the battery voltage is 10.5V to 11.3V:
(If the remaining charge is less than 10% when an Anton Bauer digital battery is being used)
> The remaining battery charge and voltage are displayed on the screen, and the display flashes.
If the battery voltage is less than 10.5V:
> END BATTERY appears on screen in red for about three seconds, and the power is turned off.
Countermeasure
Replace the battery with one containing a sufficient charge.
REMOTE specifications
RS-232C connector
For the RS-232C connector pin layout and connections,
refer to the figure below and tables on the right.
<Note>
For details on systems that use the RS-232C connector,
consult with your dealer a Panasonic Service Centre.
Pin no.
1
2
3
4
5
6
7
8
9
Signal
PC side BT-LH900E side
RS-232C
NC
TXD
RXD
NC
GND
DSR
RTS
CTS
NC
Pin no.
1
2
3
4
5
6
7
8
9
Signal
NC
TXD
RXD
NC
GND
DSR
RTS
CTS
NC
1
69
5432
87