Panasonic BT-LH900E Flat Panel Television User Manual


 
7
Parts and their functions
VIDEO OUT connector
The video signals are output from this connector.
Signals are passed through the : VIDEO IN connector
and output from this connector.
;
<
SDI input connectors
The SDI input signals are supplied to these connectors
which support automatic HD/SD switching.
=
SDI output connector
The SDI signals are output from this connector. It is the
switched output of the < SDI input connectors.
The signals displayed on the screen, whether they are
the ones supplied to the SDI 1 connector or SDI 2
connector, are output.
However, the switched output signals are not output
when the component or video input signals have been
selected.
?
External DC power socket
The external DC power source is connected here. When
a DC power supply is connected concurrently with the
battery, the external power input takes precedence.
A
Light control switch
This is not used on this monitor.
@
Tripod fastening screws
Two screws (UNC3/8-16 compatible) for securing a
tripod are provided each on the top of the monitor and at
its bottom where the main controls are removed.
A removable screw spacer is provided in one of the
screw holes in the bottom of the monitor, and this
supports a UNC1/4-20 screw. To secure the tripod, use
the hole that fits the diameter of the fastening screw on
the tripod.
>
Power switch
This is the power switch.
8
GPI connector
When GPI signals are connected here, external
operations can be performed.
9
RS-232C connector
External operations can be performed under the RS-
232C standard.
:
VIDEO IN connector
The video input signals are supplied to this connector.
Y/G
VIDEO
IN
OUT
SDI 1
IN
SDI 2
IN
SWITCHED
OUT
PB/B
PR/R
SYNC
CONTROL
GPI
RS-232C
POWER
DC IN
6
7
8
9
:
;
<
=
>
?
5
@
@
A
6
Analogue component/RGBS connectors
These are the BNC input connectors for the analogue
component (Y/Pb/Pr) or RGBS signals. When RGB
signals are supplied, external sync (gen-lock) can also
be used.
5
Battery holder
This holder is used with a battery made by Anton Bauer.
7
Main controls dedicated connector
The cable from the main controls is connected here.
<Note>
The monitor is shipped with the cable disconnected from
the connector. Prior to use, therefore, check out the
shape of the cable connector and plug it properly into this
connector.