Panasonic BT-LT2600 Flat Panel Television User Manual


 
12
Six types of information are displayed on the screen. The input signal status, picture adjusting knob status,
sharpness display, function display, audio level meter display and the menu display.
1. The selected input line (J page 9, )
VIDEO, Y/C, SDI1, SDI2,
YP
BPR/RGB-VIDEO/RGB-COMP.
2. Various display (FILM mode)
Displayed when “FILM” is selected in “GAMMA
SELECT”.
3. Signal format
The display status can be set in “STATUS
DISPLAY” in the “SYSTEM CONFIG” menu
(J page 21).
If “UNSUPPORT SIGNAL” is displayed, then either
the current input signal is not supported or the
“INPUT SELECT” menu setting needs to be
changed.
When “NO SIGNAL” is displayed, there is no input
signal.
4. Various display (lock setting)
Displayed when control lock is ON.
Note:
“UNSUPPORT SIGNAL” and “NO SIGNAL” may not be
displayed correctly.
Picture adjusting knob (J page 9, )
This knob can be rotated and pushed.
The status display appears when the knob is
pushed.
The display disappears when the knob is pushed
again, or if the knob is not operated for 10 seconds.
Settings can only be adjusted in the status display.
The display position can be changed (J page 21
“ROTARY POSITION”).
Status display:
PHASE, CHROMA, BRIGHT, CONTRAST or BACKLIGHT
Note:
The volume knob status display is not displayed on the
screen.
Sharpness is displayed when it is set.
The display disappears if remains idle for 2 minutes.
Input signal status
SDI1
412 3
Picture adjusting knob status
Sharpness display
SHARPNESS
30
How to Use the On Screen Menu