Filter
Top Products
20
English
CY-TUN153U
21
English
CY-TUN153U
No. Item Diagram Qty.
Power Connector
(YEAJ012884)
1
Head Unit/Expansion
Module Connecting
Cable
(3 m)
(YEAJ071812)
(for Expansion Module)
1
RCA Cord (3 m)
(YEAJ071819)
(for video connector)
1
RCA Cord (3 m)
(YEAJ071820)
(for audio connector)
1
RCA Cord (3 m)
(YEAJ071821)
(for remote control
connector)
1
Clip Connector
(YEAT034C012)
1
Installation
Installation Precautions
This unit should be installed by a professional installer.
In case of diffi culty, please consult your nearest
authorized Panasonic Servicenter.
This system is to be used only in a 12 V DC battery
system (car) with negative ground.
Follow the electrical connections carefully (page 26).
Failure to do so may result in damage to the unit.
Connect the power lead after all other connections are
made.
Be sure to connect the battery lead (yellow) to the
positive terminal () of the battery or fuse block (BAT)
terminal.
Insulate all exposed wires to prevent short circuiting.
Secure all loose wires after installing the unit.
Please carefully read the operating instructions of the
respective equipment before connecting it to this unit.
Installation Hardware
(For Installation)
No. Item Diagram Qty.
Tapping Screw
(516 mm)
(XTT516AFZ)
4
Velcro Tape
(YFX994C135ZA)
2
Installation Hardware
(For Wiring)
Note:
The number in parenthesis underneath each accessory
part name is the part number for maintenance and
service.
Accessories and their parts numbers are subject to
modifi cation without prior notice due to improvements.
Use the supplied screws for installation exclusively. In
case of losing any of them, please order the specifi c
screw.
19 20
Preparation
Caution
Please follow the laws and regulations of your
province or country for installation of the unit.
We strongly recommended you to wear gloves for
installation work to protect yourself from injuries.
Disconnect the cable from the negative () battery
terminal (see caution below).
Caution
If your car is equipped with air bag and/or anti-
theft systems specifi c procedures may be required
for connection and disconnection of the battery to
install this product.
Before attempting installation of this electronic
component contact your car dealer or manufacturer
to determine the required procedure and strictly
follow their instructions.
FAILURE TO FOLLOW THE PROCEDURE MAY
RESULT IN THE UNINTENDED DEPLOYMENT OF
AIR BAGS OR ACTIVATION OF THE ANTI-THEFT
SYSTEM RESULTING IN DAMAGE TO THE VEHICLE
AND PERSONAL INJURY.
Antenna Clamp 4
Cord Clamp (for antenna) 4
(YEP9FZ3041)