Panasonic CY-TUN153U Satellite TV System User Manual


 
34
English
CY-TUN153U
35
English
CY-TUN153U
33 34
Specifi cations
General
Power supply: DC 12 V (11 V–16 V), test
voltage 14.4 V,
negative ground
Current consumption: Less than 0.5 A
Video output signal: Composite video signal, 1.0
Vp-p (75 )
Audio output signal: 1 Vrms at 400 Hz
(With 100 % modulation)
Dimensions (WHD): 15622.5150 mm
{6
3
/
16
1
5
/
16
5
15
/
16
}
Weight: 650
{1 lbs. 7 oz}
TV Section
Usable Sensitivity: 36 dB/µV
Diversity Antenna
Power supply: DC 12 V (11 V–16 V), test
voltage 14.4 V,
negative ground
Current consumption: Less than 0.1 A
Output impedance: 75 4 (with mini plug)
Cord length: 6 m
Dimensions (WHD): 48034020 mm
{18
15
/
16
13
7
/
16

13
/
16
}
Weight (each unit): 330 {12 oz} (including the
cable)
Above Specifi cations comply with EIA standards.
Note:
Specifi cations and design are subject to modifi cation
without notice due to improvements.
Some fi gures and illustrations on this manual may be
different from your product.
Product Servicing
If the suggestions in the charts do not solve the problem,
we recommend that you take it to your nearest authorized
Panasonic Servicenter. The product should be serviced
only by a qualifi ed technician.
Replacing the Fuse
Use fuses of the same specifi ed rating (3 A). Using
different substitutes or fuses with higher ratings, or
connecting the unit directly without a fuse, could cause
fi re or damage to the unit.
If the replacement fuse fails, contact your nearest
Panasonic Servicenter for service.
If the Unit Fails to Operate
Reset switch
Insert a hard, slender stick into the hole and push the
switch.
IMPORTANT
Press the switch only when the unit fails to operate with
any buttons. (Stored settings and adjustments are not
cleared.) If the unit fails to return to normal condition, call
the nearest Panasonic Servicenter and ask for repairs.
Troubleshooting (continued)
Tuner for Analog TV only
This unit is not compatible with digital
television broadcasts.
Transition from analog TV broadcasts to digital TV
broadcasts:
Digital television broadcasts have begun in some
countries and regions. They are scheduled to spread
gradually into other countries and regions.
Impact on this unit:
Some countries and regions are gradually changing
analog TV broadcast channels to secure the broadcast
channels required for the start of digital TV broadcasting.
Therefore, the following effects are anticipated, but they
are not defects of this unit:
It may become impossible to receive broadcasts of
previously memorized channels.
A previously memorized channel may start receiving a
different television station.
Some channels may be selected (memorized) for which
the image cannot be displayed.
Remedy:
Check this instructions and re-select the channels (change
those memorized).