Filter
Top Products
Connections & Settings
13
VQT2U33
After completing “Easy Setting”, you can continuously
perform “Network Easy Setting”.
1 Select “Wired” or “Wireless” and press
[OK].
If “Wireless LAN Adaptor is not connected.” is displayed,
check that the Wireless LAN Adaptor is fully inserted.
Alternatively, disconnect and reconnect it. If there is still no
change in the display, consult your dealer.
2 Follow the on-screen instructions and
make the settings with [3, 4, 2, 1] and
press [OK].
For wireless LAN connection:
If you are using a Wireless router (Access point) that
supports WPS, you can easily perform the settings by
selecting “WPS (PUSH button method)”.
Otherwise, perform the settings by selecting “Search for
access point” or “Manual setting” in “Other methods”.
≥ WPS (Wi-Fi Protected Setup) is a function that facilitates
settings relating to the connection and security of wireless
LAN devices. To see whether your Wireless router
(Access point) supports WPS, check the Wireless router
operating instructions.
Access Point Connection Setting
Network Easy Setting
OK
RETURN
Network Easy Setting (Connection Check)
Wired
Wireless
Select a connection mode.
Current setting : Wired
LAN cable connection:
Connect a LAN cable to the unit and select "Wired."
Wireless LAN connection:
Connect the Wireless LAN Adaptor (DY-WL10) to the USB
port and select "Wireless."
OK
RETURN
Access Point Connection Setting
Select a connection method to use with an access point
of Wireless LAN.
Please refer to the operating instructions of the access
point about connection methods.
WPS (PUSH button method)
Other methods
p
WPS (PIN code method)
Search for access point
Manual setting
When you experience
problems with settings
Display Check the following
A conflict with another
device occurred.
≥ Please wait a few moments,
and then try again.
A time out error
occurred.
≥ Setting of the Wireless router
(Access point) for MAC
Address etc.
≥ The signal may be weak.
Using the USB extension
cable supplied with the
Wireless LAN Adaptor, adjust
the position of the Wireless
LAN Adaptor.
≥ The SSID (> 14) and the
encryption key of the Wireless
router (Access point).
≥ Please wait a few moments,
and then try again.
An authentication error
or a time out error
occurred.
A device error occurred.
≥ Connection of Wireless LAN
Adaptor
If there is no improvement in
symptom, contact our
Customer Service Center.
OK
Access Point Connection Setting
Failed to connect to the access point.
A conflict with another device occurred.
Do you want to configure Access Point Connection
Setting again ?
Yes No
DMP-BDT100_VQT2U33_eng.book 13 ページ ２０１０年６月７日 月曜日 午後１時２８分