Filter
Top Products
25
SQT0080
Settings
¾Contents Type Flag
Depending on the playback content, the TV will
output adjusting to the optimal method when a
TV that supports this function is connected.
¾HDMI(SUB) Output Mode [BDT460]
Set to output the video from the HDMI AV OUT
SUB terminal or not.
*1
A progressive image recorded at a rate of 24 frames per
second (motion-picture film). Many BD-Video movie
contents are recorded in 24 frames/second in accordance
with the film materials.
*2
A high resolution image/display technology of
approximately 4000 (width)
k 2000 (height) pixels.
∫ Dynamic Range Compression
You can listen at low volumes but still hear
dialogue clearly.
(Dolby Digital, Dolby Digital Plus and Dolby
TrueHD only)
≥ “Auto” is effective only when playing Dolby
TrueHD.
∫ Digital Audio Output
Press [OK] to show the following settings:
¾Dolby D/Dolby D +/Dolby TrueHD
¾DTS/DTS-HD
Select the audio signal to output.
≥ Select “PCM”, when the connected
equipment cannot decode the respective
audio format. This unit decodes the audio
format and transmits to the connected
equipment.
≥ If you do not make proper settings the audio
may be static or noisy.
¾BD-Video Secondary Audio
Select whether or not to mix the primary and
secondary audio (including the button click
sound).
If “Off” is selected, the unit outputs the primary
audio only.
¾HDMI Audio Output
This setting selects whether or not to output
audio from HDMI.
≥ Select “Off” when the TV is connected to this
unit via HDMI AV OUT terminal, and this unit
is also connected to other devices, such as
an amplifier/receiver via an OPTICAL
terminal.
∫ PCM Down Conversion
Select how to output audio with a sampling
frequency of 96 kHz for the PCM output from the
OPTICAL.
≥ If “On” is selected, the signals that are
converted to 48 kHz are output.
≥ If “Off” is selected, and the connected
equipment does not support 96 kHz, the sound
will not be output normally.
≥ Signals are converted to 48 kHz despite the
settings in the following cases:
– when the signals have a sampling frequency
of 192 kHz
– when the disc has copy protection
– when “BD-Video Secondary Audio” is set to
“On”
∫ Downmix
Select the downmix system of multi-channel to
2-channel sound.
≥ Select “Surround encoded”, when the
connected equipment supports the virtual
surround function.
≥ The downmix effect is not available when
“Digital Audio Output” is set to “Bitstream”.
≥ The audio will be output in “Stereo” in the
following cases:
– AVCHD playback
– Playback of secondary audio (including the
button click sound).
∫ DTS Neo:6
2ch (2.1ch) audio is expanded to 7ch (7.1ch).
≥ This function works when the following
conditions are met:
– Audio is output from the HDMI AV OUT
terminal.
– Audio recorded at 96 kHz or lower is output.
– “Digital Audio Output” is set to “
PCM
” when
audio other than PCM is output.
Audio
DMP-BDT460_360_SQT0080_eng.book 25 ページ ２０１３年１２月１９日 木曜日 午後３時０分