Filter
Top Products
33
SQT0080
Reference
Cannot play.
¾ You inserted an incompatible disc (Discs
recorded in PAL video, etc.).
Cannot display on this unit.
¾ You tried to play a non-compatible image.
¾ Re-insert the media.
No disc inserted.
¾ The disc may be upside down.
$ This operation is not available.
¾ Some operations are unsupported by the unit.
(For example, reverse slow motion, etc.)
IP address is not set.
¾ The “IP Address” in “IP Address/DNS
Settings” is “---. ---. ---. ---”. Set the “IP
Address”, “Subnet Mask”, and “Default
Gateway”. (Select the automatic address
acquisition if necessary.)
The current wireless network security setting
is weak. It is recommended to change to a
stronger security setting.
¾ Set a stronger network security level referring
to the wireless router owner’s manuals.
NET
¾ While connecting to a network.
No PLAY
¾ There is a viewing restriction on a BD-Video
or DVD-Video. (> 27)
¾ The media is dirty or badly scratched. The
unit cannot play.
REMOVE
¾ The USB device is drawing too much power.
Remove the USB device.
SET (“ ” stands for a number.)
¾ The remote control and this unit are using
different codes. Change the code on the
remote control.
Press and hold [OK] and the
indicated number button at
the same time for more than
5 seconds.
U59
¾ Temperature of this unit is hot and the unit
switches to standby for safety reasons.
Wait for about 30 minutes.
Install or place this unit with good ventilation.
H or F
(“ ” stands for a number.)
¾ There is something unusual.
¾ Check the unit using the troubleshooting
guide. If the service number remains
displayed, do the following.
1 Disconnect the plug from the AC outlet, wait a
few seconds, then reconnect it.
2 Press [Í/I] to turn the unit on.
If the service number remains displayed despite
doing the above, request service from the dealer.
Inform the dealer of the service number when
requesting service.
START
¾ The system is being restarted during the
firmware update. Please do not turn off the
unit.
UPD/
(“ ” stands for a number.)
¾ The firmware is being updated.
Please do not turn off the unit.
FIN
¾ The firmware update is complete.
Messages on the screen
Messages on the unit’s
display
DMP-BDT460_360_SQT0080_eng.book 33 ページ ２０１３年１２月１９日 木曜日 午後３時０分