Filter
Top Products
7
Safety Precautions
If problems occur during use
If a problem occurs (such as no picture or no sound), or if smoke or an abnormal odour starts to come out
from the High Definition Plasma Display, immediately unplug the power cord plug from the wall outlet.
•
If you continue to use the High Definition Plasma Display in this condition, fire or electric shock could result. After
checking that the smoke has stopped, contact your local Panasonic dealer so that the necessary repairs can be
made. Repairing the High Definition Plasma Display yourself is extremely dangerous, and shall never be done.
If water or foreign objects get inside the High Definition Plasma Display, if the High Definition Plasma
Display is dropped, or if the cabinet becomes damages, disconnect the power cord plug immediately.
•
A short circuit may occur, which could cause fire. Contact your local Panasonic dealer for any repairs that need
to be made.
CAUTION
When using the High Definition Plasma Display
Do not bring your hands, face or objects close to the ventilation holes of the High Definition Plasma Display.
•
Heated air comes out from the ventilation holes at the top of High Definition Plasma Display will be hot. Do not
bring your hands or face, or objects which cannot withstand heat, close to this port, otherwise burns or
deformation could result.
Be sure to disconnect all cables before moving the High Definition Plasma Display.
•
If the High Definition Plasma Display is moved while some of the cables are still connected, the cables may
become damaged, and fire or electric shock could result.
Disconnect the power cord plug from the wall socket as a safety precaution before carrying out any cleaning.
•
Electric shocks can result if this is not done.
Clean the power cable regularly to prevent it becoming dusty.
•
If dust built up on the power cord plug, the resultant humidity can damage the insulation, which could result in
fire. Pull the power cord plug out from the wall outlet and wipe the mains lead with a dry cloth.
Cleaning and maintenance
The front of the display panel has been specially treated. Wipe the panel surface gently using only a
cleaning cloth or a soft, lint-free cloth.
•
If the surface is particularly dirty, wipe with a soft, lint-free cloth which has been soaked in pure water or water
to which a small amount of neutral detergent has been added, and then wipe it evenly with a dry cloth of the
same type until the surface is dry.
•
Do not scratch or hit the surface of the panel with fingernails or other hard objects, otherwise the surface may
become damaged. Furthermore, avoid contact with volatile substances such as insect sprays, solvents and
thinner, otherwise the quality of the surface may be adversely affected.
If the cabinet becomes dirty, wipe it with a soft, dry cloth.
•
If the cabinet is particularly dirty, soak the cloth in water to which a small amount of neutral detergent has been
added and then wring the cloth dry. Use this cloth to wipe the cabinet, and then wipe it dry with a dry cloth.
•
Do not allow any detergent to come into direct contact with the surface of the High Definition Plasma Display.
If water droplets get inside the unit, operating problems may result.
•
Avoid contact with volatile substances such as insect sprays, solvents and thinner, otherwise the quality of the
cabinet surface may be adversely affected or the coating may peel off. Furthermore, do not leave it for long
periods in contact with articles made from rubber or PVC.