Filter
Top Products
8
Y
P
B
PR
Y
P
B
PR
COMPONENT VIDEO
INPUT
INPUT 1 INPUT 2OUTPUT
S VIDEO
12
L
R
VIDEO
AUDIO IN
DIGITAL
AUDIO
OUT
SERVICE
ONLY
ANT
2
Setting-up
3
Stopping the plasma television from falling over
* Carry out work on a horizontal and level surface.
Lift the television unit above the pedestal base,
with the back of the television unit on the same
side as the Pedestal No. label. Then align the
holes in the television unit with the poles of the
pedestal and lower the television unit into place.
Use the assembly screws
B
(M5 x 30) to fasten
securely.
Accessories/Options
Securing to a base. Securing to a wall.
* Remove the screws
at both top corners on
the rear side of the
plasma TV, and attach
the clamps
to the
plasma TV using the
removed screws.
* Use strong wire
or chain which is
commercially available
to secure the plasma
television to a solid
area of the wall or a
pillar.
Remove the plasma television unit from its packing box, spread a clean blanket or other covering on a level
floor or stand, place the television on the floor or stand with its front panel facing down, and keep it like this
until installing it on the pedestal.
Securing the television unit
* The plasma TV must be fastened to both the base and the wall.
Pedestal No. label
Pedestal
Television unit
Rear
Front
Front
Wood
Worktop
Fasten with wood screws in the holes
in the back edge of the wood worktop.
If there are no holes, first drill them in
the middle of the thickness of the wood
worktop, and then fasten the strap with
wood screws.
• Securing method
Screws on main body
Do not remove this screw.