18
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at:http://www.panasonic.com/contactinfo
Please make all cable or antenna
connections before powering on.
Plug the unit power cord into an AC wall
outlet.
Settings are made
automatically. When
complete, this screen
appears.
If setup is incomplete,
the following screen
appears. Check
connection of
Antenna/Cable to the
RF in Terminal, then
try to manually set the
clock as follows.
a. Press ACTION on the Remote to
display SET CLOCK Menu screen.
b. Press ▲▼ to select the month and
press SET to set. In the same
manner, select and set the date, year,
time, and DST (Daylight Saving Time).
• Press ◄ repeatedly to move the cursor. Press
▲▼ to make a correction.
c. Press ACTION twice to start CLOCK
and exit.
POWER
ACTION
SET
CH AUTO SET PROCEEDING
AUTO CLOCK SET
PROCEEDING
CANCEL:STOP
10/25/2004 MON 11:45AM
DST:ON
SETTING : CH 10
AUTO CLOCK SET
COMPLETED
AUTO CLOCK SET
IS INCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACTION KEY
SET CLOCK
1/ 1/2004 THU 12:00AM
DST:ON
SELECT: SET:SET
START :ACTION
SET CLOCK
10/25/2004 MON 11:45AM
DST:ON
SELECT: SET:SET
START :ACTION
Case 1
Case 2
Initial Setup (Ready to Play)
Initial Setup -Ready to Play-
• Function buttons are void during Initial Setup.
• To eject a tape during Auto Set, press EJECT on
remote. Then make settings manually. (See
pages 19-21.)
• If Auto Clock Set takes more than 30 minutes,
press STOP and perform settings manually. (See
pages 19-21.)
SELECT
▲▼◄►
EJECT
STOP
• If you use a cable box, turn it on and set it to the
Public Broadcasting Service (PBS) channel in
your time zone. If you use a DSS receiver, it
must be turned off.
Press POWER on the remote or unit. Auto
channel and clock set starts.
POWER
STOP