Filter
Top Products
Getting Started
7
Setting up the remote commander
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove the batteries
to avoid possible damage from battery leakage.
• Do not use a new battery together with an old one.
• Do not use different types of batteries together.
• Some buttons may not work with certain Sony TVs.
* not available on SLV-SE600B
Controlling other TVs with the remote commander
(not available on SLV-SE600B)
The remote commander is preprogrammed to control non-Sony TVs. If your TV is
listed in the following table, set the appropriate manufacturer’s code number.
* These buttons may not work with all TVs.
Adjust the volume of the TV 2 +/–
Switch to TV (Teletext off)* a (TV)
Switch to Teletext* / (Teletext)
Select the sound CHOIX SON
Use FASTEXT* FASTEXT buttons
Call up the on-screen display
AFFICH
Change the Teletext page* c/C
Switch to/from wide mode of a Sony wide TV (For other
manufactures’ wide TVs, see “Controlling other TVs with
the remote commander (not available on SLV-SE600B)”
below.)
WIDE
1
Set [TV] / [MAGN] at the top of the remote commander to [TV].
2
Hold down ?/1, and enter your TV’s code number using the programme number
buttons. Then release ?/1.
Now you can use the following TV control buttons to control your TV:
?/1, t TV/MAGN, programme number buttons, - (ten’s digit), CHAINE +/–,
2 +/–, a (TV), / (Teletext), FASTEXT buttons, WIDE*, MENU*,
M/m/</
,*, and OK*.
To Press
continued