Filter
Top Products
Basic Connection
10
Basic Connection
External equipment and cables shown are not supplied with this TV.
Please ensure that the unit is disconnected from the mains socket before attaching or disconnecting any leads.
Rear of the TV
■ Clamper
Attach the clamper Bundle the cables
To remove from the TV:
To loosen:
Mains lead
Aerial
AC 220 - 240 V,
50 / 60 Hz
(
TH-P42VT30P, TH-P50VT30P
:
AC 110 V - 240 V, 50 / 60 Hz
)
Fully wired HDMI
compliant cable
RF adaptor
(supplied)
Set top box
Satellite dish
hole
Insert the
clamper in a
hole
hooks
Set the
tip in the
hooks
Keep
pushing
both side
snaps
snaps
knob
Keep
pushing the
knob
Ferrite core - Middle size
(supplied: TH-P42VT30Q, TH-P50VT30Q)
Installing the Ferrite core
Pull back the tabs
(in two places)
Press the cable
through and close
Caution
•
Please use the supplied RF adaptor with the supplied
middle size ferrite core to comply with the EMC standard.
Open
Less
than
10 cm
RF cable
Note
•
Keep RF (antenna) cable away from the mains lead to avoid and minimise mains interference pickup.
•
Do not place the RF cable under the TV.
•
To obtain optimum quality picture and sound, an aerial, the correct cable (75
Ω
coaxial), and the
correct terminating plug are required.
•
If a communal aerial system is used, you may require the correct connection cable and plug between
the wall aerial socket and the TV.
•
Your local Television Service Centre or dealer may be able to assist you in obtaining the correct aerial
system for your particular area and the accessories required.
•
Any matters regarding aerial installation, upgrading of existing systems or accessories required, and
the costs incurred, are the responsibility of you, the Customer.
•
To obtain optimum quality picture, select either an Aerial or a cable TV network.
•
VIERA Link connection (p. 68)
•
Other equipment connection (p. 73 - 75)
•
Read the manual of the equipment, too.