Panasonic TH-P50VT30M TH-P42VT30V TV Antenna User Manual


 
Auto Tuning
15
Setup the network connection
Set up the network connection to enable the network service functions such as VIERA Connect, etc.
(p. 17, 67)
To set up the wireless connection, the Wireless LAN Adaptor is required.
Please note that this TV does not support wireless public access points.
Ensure the network connections and network environment are completed before starting setup.
1
Connect the LAN cable or Wireless LAN Adaptor
To enable the network service functions (VIERA Connect, etc.), you need to connect the TV to a
broadband network environment.
Internet
environment
Internet
environment
Wired connection
Wireless connection
Access point
LAN cable
Wireless LAN Adaptor
(supplied: TH-P42VT30V,
TH-P50VT30D, TH-P50VT30K,
TH-P50VT30T, TH-P50VT30V)
Connect to the
USB 1, 2 or 3 port.
or
Rear of the TV
Setup Wireless
LAN Adaptor
Insert straight in
If you do not have any broadband network services, please consult your retailer for assistance.
For more information of the network connections (p. 59)
Caution
To use the Wireless LAN Adaptor, an Access Point needs to be obtained.
It is recommended to use the Wireless LAN Adaptor with the extension cable.
To avoid radio wave interference, keep the TV away from the devices such as other wireless
LAN devices, microwaves and the devices that use 2.4 GHz and 5 GHz signals when using the
Wireless LAN Adaptor.
Otherwise malfunction may occur.
2
Select [Wired] or [Wireless]
Network Setup
Select Wired or Wireless
Wired Wireless
Set later
access
select
3
Start the settings
[Wired]
Select [Auto]
Acquire IP Address
Auto Manual
access
select
To set manually, select [Manual] and set
each item. For details
(p. 61 - 62)
Check network cable connection.
Check acquired IP address.
Check for devices using same IP address.
Check gateway connection.
Check server connection.
Connection Test
Automatically setup is done and the test of the
network connection starts.
: succeeded
The test is successful and the TV is
connected to the network.
: failed
Check the settings and connections, and
then select [Retry]