Filter
Top Products
If required, use commer-
cially available M6
bolts which suit the wall
materials.
If the Screws protrude
more than 5 mm, it will
not be possible to install
the Wide Plasma Display
in the correct position.
Place the display unit
face down on top of a
cloth clean and free from
otherforegin particles,
and then proceed to the
next step.
Spread a clean cloth over a level floor or base, and place on it the display
unit face down.
Remove the four screws from the display.
1
Use the accessory tool "Allen key" to install the four accessory ,
and into the holes.
2
Fixing the insulating spacers to the display
unit
Pan head bolt with
hex socket
Toothed pan washer
Insulating spacer
3
Use a level gauge to correct the alignment of the wall-hanging bracket,
and screw bolts into the remaining five holes.
Insert and fasten a M6 screw bolt into the center-top hole.
2
Provisionally tighten the fixing screws.
4
4-5