Filter
Top Products
2
Safety precautions
WARNING
Ensure that the installation location is strong enough to support long-term use.
• If its strength becomes insufficient over the course of long-term use, the plasma TV may drop, possibly causing
injury.
Fitting work and connection equipment expansion should never be done by any other than a qualified
installation specialist.
• Incorrect fitting may cause equipment to fall, resulting in injury.
Include a safety factor when considering the strength of the proposed fitting location.
• If strength is not sufficient the equipment may fall, resulting in injury.
Do not fit at a location that cannot bear the load.
• If the fitting location lacks sufficient strength the equipment may fall.
Do not disassemble or modify the wall-hanging bracket.
• Otherwise the unit may be dropped and become damaged, and personal injury may result.
CAUTION
Do not use any television and displays other than those given in the catalogue.
• Otherwise the unit may be dropped and become damaged, and personal injury may result.
Do not fit at any locations subject to humidity, dust, smoke, steam or heat.
• This may have an adverse effect on the plasma TV and cause fire or electric shock.
The work of fitting or removing the plasma TV must be performed by at least two people.
• The plasma TV may fall and cause injury.
Do not fit facing upwards, sideways or upside down.
• This may cause heat to build up inside the plasma TV unit, resulting in a fire.
Leave clearances all around the plasma TV of at least 10 cm (39.3 inches) above, at least 10 cm (39.3 inches)
on the left, at least 15 cm (59.1 inches) on the right and at least 10 cm (39.3 inches) below. Ensure that the
space between the back of the plasma TV and the wall behind is not blocked.
• The plasma TV unit has air blow holes on the top, and air suction holes on the bottom and rear. Covering these
may result in a fire.
Install the plasma TV by taking only the steps which are specified in these instructions: Do not install it in
any other way.
• Otherwise the unit may be dropped and become damaged, and personal injury may result.
Install the mounting screws and power cable in such a way that they will not make contact with the inside
parts of the wall.
• Electric shocks may result from contact with any metal objects inside the wall.
For installation, use the special-purpose constituent parts.
• Otherwise, the plasma TV may fall off the wall, possibly causing injury.
Remove the product that will not be used any longer.
• Otherwise the product may fall down and personal injury may result.
Requests regarding handling
1) Exercise care when selecting the location for the TV because it may discolor or deform due to light or heat if
it is placed where it is exposed to direct sunlight, or near a heater.
2) Clean the wall-hanging bracket by wiping it with a soft, dry cloth (such as cotton or flannel). If the bracket is
very dirty, remove the dirt using a neutral detergent diluted in water, and then wipe it clean with a dry cloth.
Do not use benzene, thinner, or furniture wax as this may cause the coating to peel.
(For information on cleaning the display unit, see the display unit’s instruction manual. If using a chemically-
treated cloth, follow the instructions supplied with the cloth.)
3) Do not affix adhesive tape or stickers to the product. Doing so may dirty the surface of the wall-hanging
bracket. Do not allow long-term contact with rubber, vinyl products or the like. (Doing so will cause
deterioration.)
4) Take care during installation as shocks can cause ‘panel cracks’ to the plasma TV unit.
Caution:
This bracket is intended for only Panasonic plasma TV models (See back cover).
Use with other apparatus is capable of resulting in instability causing possible injury.
PROFESSIONAL INSTALLATION IS REQUIRED.
PANASONIC DISCLAIMS ANY PROPERTY DAMAGE AND/OR SERIOUS INJURY, INCLUDING DEATH
RESULTING FROM IMPROPER INSTALLATION OR INCORRECT HANDLING.
English