Filter
Top Products
87
■ Alarm Suspension
This function disables the activation of the alarm link and
instead enables storing of any alarm activated in the
ERROR REPORT table.
It is used to suspend the alarm link during the Disk
Recorder’s setup.
To suspend the alarm:
1. Press the ALARM RESET and REC PREVIEW buttons
at the same time.
The ALARM SUSPEND indicator lights to indicate that
this function is selected.
2. Press the ALARM RESET button to reset the alarm sus-
pension.
The ALARM SUSPEND indicator goes off.
■ Alarm Reset
● Manual Reset
When the alarm is activated, the ALARM indicator blinks.
The indicator keeps blinking until all alarms are cleared by
pressing the ALARM RESET button.
The blinking or lit indicator goes off.
● Auto Reset
The alarm is automatically reset after the programmed
alarm Auto Reset time has elapsed or the lost video signal
has been recovered.
The ALARM indicator changes from blinking to a steady
light.
Pressing the ALARM RESET button will clear the alarm
and switch the indicator off.
● External Reset
The alarm is reset by a recovery signal received from the
external equipment at pin 8 of the ALARM port located on
the rear of the Disk Recorder.
The ALARM indicator changes from blinking to a steady
light.
ALARM
ALARM
RESET
ALARM
RESET
ALARM
SUSPEND
ALARM
RESET
ALARM
SUSPEND
REC PREVIEW