Filter
Top Products
Bulletin 4480-T7-US Karrykrimp 2
Parker Hannifin Corporation
Hose Products Division
Wickliffe, OH
10
Hose Insertion Depth
Hose by Fitting Series
Dash Size 26 43 70 71 73/78 81
-4 13/16” 13/16”
-5 13/16” 15/16”
-6 13/16” 1-1/8” 1-1/16” 1-1/16”
-8 13/16” 1-5/16” 1-5/16” 1-1/4”
-10 7/8” 1-9/16” 1-3/8” 1-5/16”
-12 7/8” 1-1/2” 1-1/2” 1-7/16” 1-7/8” 1-1/8”
-16 1” 1-3/4” 1-13/16” 1-3/4” 2” 1-1/4”
-20 1-7/8” 1-13/16” 1-5/16
Note: See Hose Insertion Depth table at the
right.
Important: Hose assemblies must be inspected
for cleanliness and free of all foreign particles.
Note: Parker Hannifin will not accept
responsibility for the operations of, or provide
warranty coverage for, a crimper that is
operated by a power unit other than equipment
supplied by Parker Hannifin for the expressed
purpose of operating the designated crimper.
Crimping Instructions for 26, 43, 70, 71, 73, 78 and 81 Series Fittings
1. The Hose Insertion Depth fixture can
be used to mark the insertion depth
on the hose.
2. Push the hose all the way into the
coupling to the insertion depth mark.
Do not use lubricant to assemble
spiral hose and fittings.
3. Remove pin from inside pusher unit
so pusher will swing back. Lubricate
the die bowl cavity to prevent wear.
4. Place unitized die-train in bowl. See
decal on crimper for proper die set.
Note: Die sets are color coded by size.
5. Position the hose and fitting in dies
from below.
6. Rest bottom of coupling on die step
using PARKALIGN
®
feature.
7. Place the die ring on top of the dies.
See decal on crimper for proper die
ring; Silver and Black.
8. Reposition pusher, replace pin,
operate pump until ring bottoms out
on base plate.
9. Release pump pressure and remove
finished assembly.
Crimping Instructions
PARKALIGN
®
Feature