Filter
Top Products
Bulletin 4480-T7-US Karrykrimp 2
Parker Hannifin Corporation
Hose Products Division
Wickliffe, OH
7
1. Remove crimper and all accessories from shipping crate.
Verify that you have received the following items:
• Base Machine 85C-080
• Silver Die Ring 85C-R01
• Black Die Ring 85C-R02
• Hose Assembly 85C-00L
• Stand Assembly 832021
• Technical Manual 4480-T7-US
• Grease
• Training Video/CD
2. Assemble crimper base unit to stand as shown in Figure 2.
Place machine on sturdy bench. It is recommended that the
machine be bolted to the bench. Two 1/2” holes are provided
in the stand for this purpose. Make sure crimper base over-
hangs bench to allow access from below base plate.
3. Connect hose assembly to power unit and to crimper
cylinder. Follow instructions supplied with power unit for
venting, checking oil level, or general usage.
4. Place die ring in position on crimper base. Cycle cylinder up
and down a few times to purge air from system. Recheck
oil level in power units. Make sure cylinder is fully retracted
before adding any hydraulic oil.
5. Your machine is now ready for use. Please read the
remainder of this manual before proceeding to crimp any
hose assembly.
Figure 2
Installation