Filter
Top Products
Bulletin 4480-T7-US Karrykrimp 2
Parker Hannifin Corporation
Hose Products Division
Wickliffe, OH
12
SYMPTOMS POSSIBLE CAUSES WHAT TO DO
Hand pump, air/hydraulic pump,
electric pump, pump hose
assembly, quick disconnect
problems.
Refer to Enerpac instructions or
call Enerpac at 1-800-558-0530
Coupling crimp diameter above
or below specification.
Wrong fitting style being used. Only approved fittings can
be used with Karrykrimp 2
machine. For a complete
selection and correct
combinations of hose and
fittings, see Catalog 4400.
Wrong hose being used.
Only approved hoses can
be used with Karrykrimp 2
machine. For a complete
selection and correct
combinations of hose and
fittings, see Catalog 4400.
Wrong die ring being used.
Refer to die selection chart or
Catalog 4400 for correct die
ring.
Pusher is not being bottomed
out on die ring and base plate
completely (usually inconsistant
crimp diameters).
Lubricate die cavity with Citgo
MP Lithoplex lithium grease
or equivalent. Bottom out
the pusher on the die ring
completely. Can also check for
proper bottoming by placing
a piece of paper between die
ring and base plate. If properly
bottomed, should not be able to
remove paper.
Pump relief valve set too low.
Adjust relief valve setting to
10,000 psi.
High or low voltage. Call a qualified electrician.
Low on oil. Refill oil reservoir with Enerpac
oil.
If you have a problem with your Karrykrimp 2 machine...
First, check that the proper tooling, hose and fitting combinations are being used.
Then check the following recommendations. If after the following suggested remedy, the problem
persists, call our Technical Service Department (440) 943-5700.
Trouble Shooting Guide