Filter
Top Products
C695M-B (11/03) 15
PROGRAMMING
MENU STRUCTURE
All programming operations are performed in SETUP mode. Use either the DX3100 front panel buttons or the IR remote controller to
program the unit. The programming menu tree is shown in Figure 7.
PELCO DX3100 RECORDER
RECORDER SETUP
CAMERA SETUP
ALARM SETUP
NETWORK SETUP
SYSTEM STATUS & UPGRADE
ENG/DEU/ESP/FRA/POR
RECORDER SETUP
IMAGE SIZE
IMAGE RATE
PAGE SEQUENCE
DWELL
PASSWORD
TIME/DATE SET
TIME FORMAT
DAYLIGHT SAVING
IR-REMOTE ID
PTZ PROTOCOL
[352X240][640X240]
16 ips (1-30)
[ON][OFF]
5 sec (1-60)
[EDIT][CREATE]
SAT, 04/22/2002
AM 10:00:00
AM/PM OR 24HR
US
01 (00-99)
PELCO "P" or "D"
EDIT PASSWORD
STATUS
OLD
NEW
CONFIRM
[ADMIN][USER]
[SAVE]
CREATE USER PASSWORD
NEW
CONFIRM
[SAVE]
CAMERA SETUP
[CH1] TO [CH16]
CAMERA SETUP
CAMERA NAME:
RECORD:
RECORD PARAMETER:
RECORD TIME (24 HR):
IMAGE QUALITY:
MOTION SENSITIVITY:
PTZ RX ADDRESS:
BRIGHTNESS:
CONTRAST:
HUE:
CHROMA-U:
CHROMA-V:
CH1
[ON][OFF]
00 TO 24
70 (100= Best)
100
DEFAULT/MANUAL
(100= Most)
00
50
50
50
50
50
ALARM SETUP
[ALARM 1] TO [ALARM 4]
ALARM SETUP
ALARM ACTIVE (24 HR):
ALARMED CAMERA:
ALARM CONTACT TYPE:
RECORD MODE:
RECORD TIME:
ALARM RELAY OUT 1:
ALARM RELAY OUT 2:
00 TO 24
1
[NO][NC]
[SET][DURATION]
5 sec (1-99)
[ON][OFF]
[ON][OFF]
NETWORK SETUP
CONNECTION:
IP ADDRESS:
SUBNET MASK:
GATEWAY:
PASSWORD:
[LAN]
192.168.000.002
255.255.255.000
192.168.000.001
[EDIT]
SYSTEM STATUS & UPGRADE
SIGNAL SYSTEM:
HDD SPACE USED:
SOFTWARE VERSION:
HARDWARE VERSION:
IP ADDRESS:
MAC ADDRESS:
SOFTWARE UPGRADE:
NTSC
10.0 / 60.0 GB
V1.1.0
V1.1
192.168.000.002
00:06:38:00:00:02
[FDD] [LAN]
ENG / DEU / ESP / FRA / POR
LANGUAGE: ENGLISH
[LOAD NEW]
EDIT NETWORK PASSWORD
NEW
CONFIRM
[SAVE]
OR NONE
Figure 7. Menu Tree