Filter
Top Products
Perle C/CM-10GT Media Modules Installation Guide
14
Loopback Test
This mode is not used in conjunction with BILT.
1. If either media converter module is not a Perle 10GT module
then you need to set loopback mode on one of the media
converter modules. (See the User’s Guide that came with that
media converter module).
2. Use an alternative way to generate data to the unit set in
loopback mode. Data received on the receiver (RX) will be
looped back to the transmitter (TX) connection. Use a third
party application to analyse the received data.
Module Temperature Protection
All C/CM-10GT modules come equipped with module temperature
protection. Should an inserted SFP+ or XFP module operate
above its specified maximum operating temperature, the C/CM-
10GT will reduce the power to that module. The C/CM-10GT will
continue to monitor the modules’ temperature until the
temperature is below the maximum operating temperature and
then the C/CM-10GT will return the module to normal operating
mode.