Filter
Top Products
Perle C/CM-10GT Media Modules Installation Guide
9
EEE (Energy Efficient Ethernet)
Switch Position Mode
Up (default) Enabled
Down Disabled
Enabled: When enabled, the media converter will auto negotiate
this capability with the attached EEE compliant devices/servers.
Disabled: The media converter will not auto negotiate this
capability with the attached EEE compliant devices/servers.
Installing Modules
1.
Set any jumpers and/or DIP switches on the module to the
desired operating mode.
2.
Gently slide the module into the slot until it becomes flush with
the front of the chassis. Light pressure may be needed to seat
the module. Do not force the module as you might damage the
module. If there is resistance, remove the module and check
the module’s backplane connector for damage to the pins. If
the module’s backplane connector is not damaged, try to
reinsert the module again.
3.
Tighten the Captive retainer screw to ensure the module is
locked in place.
Caution: Observe electrostatic discharge precautions when
installing or removing the module(s) from the Chassis. Failure to
observe this caution could result in damage to the module(s)
and/or chassis.