Filter
Top Products
Perle C/CM-10GT Media Modules Installation Guide
8
Fiber Fault Alert Sample Config
Media Converter Module A Configuration
Link Mode–Standard Mode
Fiber Fault Alert
Media Converter Module B Configuration
Link Mode–Smart Link Pass through Mode
Fiber Fault Alert
Sequence of Events
1. Media Converter Module
A
loses fiber connection (RX).
2. Media Converter Module
A
notifies the remote Media
Converter Module that there is a fault on the Link.
3. Media Converter Module
B
detects loss of fiber link on
receiver (RX).
4. Media Converter Module
B
turns off transmitter (TX).
Port Selection (Switch 3 – Test Mode)
Switch Position Port
Up (default) 1
Down 2
When Loopback mode is selected (Switch 1 and Switch 2 down),
this switch specifies which port to enable loopback mode on.