Filter
Top Products
Solution
– Check if the AC power cord is properly connected.
– Check if the TV is switched on.
– Check the video connection.
– Sometimes a small amount of picture distortion may appear.This is not a malfunction.
– Connect the DVD system directly to the TV.
– Make sure the disc is compatible with the DVD system.
– Adjust the volume.
– Check that the speakers are connected correctly.
– Check the digital connections.
– Check if the audio format of the selected audio language matches your receiver capabilities.
– Use a DIGITAL AUDIO OUT jack when outputting the DTS audio.
– Check that the SCART cable is connected to the correct device (See Connecting to a TV)
– Check the disc for fingerprints/scratches and clean with a soft cloth wiping from centre
edge.
– This may happen when you use the disc recorded in the non-seamless manner.This is not a
malfunction.
– Ensure the disc label is facing up.
– Check if the disc is defective by trying another disc.
– Reset the unit by switching the DVD system off,then on again.
– Aim the remote control directly at the sensor on the front of the System.
– Reduce the distance to the System.
– Replace the batteries in the remote control.
– Re-insert the batteries with their polarities (+/– signs) as indicated.
– To completely reset the System,unplug the AC cord from the AC outlet for 5-10 seconds.
– Operations may not be permitted by the disc.
Refer to the instructions of the disc.
– Use a commonly available cleaning CD/DVD to clean the lens before sending the DVD sys-
tem for repair.
– Playback will stop for more than 35 minutes and no button is pressed.
– Make sure the tape has a record tab.
– Make sure the System is in VCR position.
– Check the TV and the System channel are similar.
– Make sure the recording start and stop times are set correctly.
– Make sure the tape has a record tab.
– Make sure the clock is set.
– The System may not perform or continue a timer recording if the power fails for more than
1 minute.
–To enable quick play mechanism,the cylinder will rotate for about five minutes.This is nor-
mal.
– Insert a tape, window side up with the record tab facing you.
– Gently push on the center of the tape when putting into the System.
– Make sure the power plug is completely connected to a power outlet.
– Make sure the tape has a record tab.
– If the signal is too weak,adjust the antenna or connect an external antenna for better
reception.
– Increase the distance between the System and your other electronics equipment.
Problem
No power
No picture
Distorted picture
Completely distorted picture or
black/white picture with DVD
No sound or distorted sound
No audio at digital output
No DTS audio at analog output
No sound and picture
Picture freezes momentarily during
playback
Disc can’t be played
No return to start-up screen when disc is
removed
The System does not respond to the
remote control
Buttons do not work or the System stops
responding
The System does not respond to some operat-
ing commands during playback.
The DVD system cannot read CDs/DVDs
The System switches from DVD mode to VCR
mode after 35 minutes
The VCR do not record a TV program
The System does not perform a timer
The motor (cylinder) rotates even when tape
playback is stopped
You cannot insert a tape
You cannot remove a tape
The System ejects the tape when you press REC
or TIMER SET for a timer recording.
Radio reception is poor.
23
English
Specifications
VCR Video Heads
Four heads - Hi-Fi
Antenna
VHF/UHF - 75 ohm external antenna terminal
RF Output Signal
Channel 22 to 69
75 ohms unbalanced
DVD Color System
PAL
Amplifier
Output power (rms,4 ohms,1 kHz, 10% Total
Harmonic Distortion) 360W total
- Front 75W/channel
- Center 75W
- Rear (Surround) 75W/channel
- Subwoofer 75W
FTC(Federal Trade Commission)
(4 ohms,120 Hz to 12.5 kHz,
10 % Total Harmonic Distortion)
2 X 60W
Frequency Response
DVD (linear sound):
20 Hz to 22 kHz
(sample rate:48 kHz)
20 Hz to 44 kHz (surround off)
(sample rate:96 kHz)
Audio CD:20 Hz to 20 kHz
Signal-to-Noise Ratio
Audio CD:120 dB (JEITA:
Japan Electronics and Information Technology
Industries Association)
Dynamic Range
DVD (linear sound): 99 dB
Audio CD:99 dB (JEITA)
Total Distortion Factor
Audio CD:0.003% (JEITA)
DVD: 0.003%
Wow and Flutter
Below the measurement limitation
(±0.001% W PEAK) (JEITA)
Power Requirement
220–240V AC, 50 Hz
Power Consumption
Power on: 50 W
Power off (standby):5 W
(WhenCLOCK DISPLAYset toOFF.)
Operating Temperature
5°C to 40°C
Relative Humidity
30% to 80%
Dimensions (w x h x d)
Receiver (System):
43.5 x 9.9 x 39.2 cm
Front Speakers:
9.4 x 15.5 x 8.9 cm
Rear Speakers:
9.4 x 15.5 x 8.9 cm
Center Speaker:
43.5 x 7.2 x 6.4 cm
Subwoofer:
19.6 x 39.1 x 43.2 cm
Weight
7.8 kg.
NOTE:Designs and specifications are subject to
change without notice.
Troubleshooting
If you are unable to remedy a problem by following these hints, consult your dealer or service centre (HOTLINE).
E9015ED_EN.qx3 03.7.29 6:32 PM Page 23