Filter
Top Products
c Press C .
TIMER PROGRAMMING
VPS
DATEPROG. START END LP PDCREP.
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
15 xxx 15:36 15:50 - * ONCE
Store:
press OK
d Select the entry field ’PROG.’ with the D or C
button. Select ’Record prepared’ with the B or
A button.
e Confirm with the OK button.
Your TV-VIDEO Combi is now prepared for recording. The
start and end of the recording is controlled via the scart
cable.
f To end, press the TIMER s button.
g Place a cassette in the machine.
E If you have not connected the satellite receiver yet, use a
scart cable to connect scart socket EXT.1 on the
TV-VIDEO Combi to the corresponding scart socket on
the satellite receiver.
h Programme the satellite receiver with the required
information (programme number on the SAT receiver,
start time, end time).
DThe information on how to programme your satellite
receiver can be found in the instruction manual for
your satellite receiver.
Activating a recording from the SAT
receiver with OTSR (OTSR = One Touch Sat
Recording)
In the previous paragraph we described how to prepare the
TV-VIDEO Combi for recording from the SAT receiver by
means of the menu (step a through f ). OTSR will allow
you to record a SAT programme fast and easy with just one
button press.
a Press the Sr/q buttons at the same time until the
timer light on your TV-VIDEO Combi starts blinking. It will
blink three times and will then stay alight.
Your TV-VIDEO Combi is now prepared for recording. The
start and end of the recording is controlled via the scart
cable.
DEach time you programme a recording on the
satellite receiver, you must prepare your TV-VIDEO
Combi for recording. Each time you prepare your
TV-VIDEO Combi for a satellite recording a
TIMER-block will be reserved and the TIMER light at
the front will blink.
DIf the TIMER light does not blink, you have not set
the clock or all TIMER-blocks have been used up.
Please read the paragraph ’Setting the time and
date’ or ’How to clear a programmed recording
(TIMER)’.
DIf you want to cancel the programmed SAT
recording, follow the procedure described in the
paragraph ’How to clear a TIMER’.
How to check or change a TIMER
a Press the TIMER s button on the remote control.
b Select the line ’TIMER PROGRAMMING’ with the
menu buttons B or A and confirm with the C
button.
c Select the TIMER you want to check or change with the
B or A button and confirm with the OK button.
d Select the entry field with the D or C button.
e Change any information with the B or A button or
with the 0-9 buttons.
DUnder ’LP’, use the B or A button to select the
recording speed ’SP’ or ’LP’.
f Confirm with the OK button.
g To end, press the TIMER s button.
h Make sure that the cassette you have put in can be
recorded on.
How to clear a TIMER
a Press the TIMER s button on the remote control.
b Select the line ’TIMER PROGRAMMING’ with the
menu buttons B or A and confirm with the C
button.
c Select the TIMER you want to clear with the menu
buttons B or A .
d Press the CLEAR button.
e Switch off with the TIMERs button.
20