Filter
Top Products
7
AUTO PROGRAM (SETTING UP CHANNELS)
Y
our LCD TV can automatically set itself for local
area (or cable TV) channels. This makes it easy
for you to select only the TV stations in your area by
pressing the CH (+) or CH (-) button.
Press the MENU button on the remote
control to show the onscreen menu.
Press the CURSOR DOWN button to
highlight the INSTALL menu.
Press the CURSOR RIGHT button
to enter the INSTALL menu.
Press the CURSOR DOWN button to
highlight the AUTO PROGRAM control.
Press the CURSOR RIGHT button to
start the AUTO PROGRAM scanning
of channels.
Press the MENU button repeatedly to
clear the menu from the screen, after
AUTO STORE has finished.
1
2
3
4
5
6
A/CH
AV
i
+
AUTO STORE
PLEASE WAIT
PROG.FOUND 0
INSTALL
LANGUAGE
START?
MAIN CONTROLS
PICTURE
AUDIO
FEATURES
INSTALL
3
5
2
4
1
6
AUTO PROGRAM
FREQUENCY
MHZ
MANUAL STORE
CHANNEL SETTING
LANGUAGE
AUTO PROGRAM
FACTORY RESET
MANUAL STORE
CHANNEL SETTING
FACTORY RESET
• Immediately after unpacking and plugging in your new television, run the auto
program function to set up the TV for the broadcast or cable channels available in
your area. If you do not run the auto program function to set up the channels ,
your television may not operate properly.
• After you’ve run Auto Program, check out the results. Press the CH (+) or the CH (-)
button and see which channels you can select.
• Remember, an antenna or cable TV signal must first be connected to your LCD TV.
HELPFUL HINT