Filter
Top Products
Problems and Solutions:
The message “WRONG VERSION” is displayed on the screen.
=> The program stored into the Wireless Smart-Loader has a software code incompatible with
the actual TV. Reprogram the Wireless Smart-Loader from a master TV whose software code
is compatible with the actual TV.
1. The message “I2C ERROR” is displayed on the screen.
=> Bad connection of RJ11 wire or wrong data transmission occurred. Please check the RJ11
connection and try again.
2. TV doesn’t respond to the Wireless Smart-Loader.
=> check if the LED on the Wireless Smart-Loader is green when pressing any button and
check if the batteries are in a good condition. Replace batteries if necessary.
=> try to bring the Wireless Smart-Loader more closer to the TV infra red receiver and try
again.
Tips:
1. Do not forget to write the software code and the type of relevant master TV on the sticker
used on the back of the Wireless Smart-Loader.
2. In case of empty or no batteries available, it remains possible to install TVs using the “wired
method” of the Wireless Smart-Loader.
3. The Wireless Smart-Loader can retain, without batteries, the stored information for ten years
if required.
NOTE:
Before putting the Wireless Smart-Loader into store for a long time, make sure that the
batteries are all taken out to prevent the batteries corroding the contacts.
Wired Smart-Loading works with CRT TVs only. Wireless Smart-Loading works with both
Flat TVs and CRT TVs.
Press the
key for approximately 5 seconds. The following text then appears:
If the word “LOW” appears instead of “OK”, the remote control batteries are low and must be replaced.
- 19 -