Filter
Top Products
EN 24
When digital TV channels are found, the
list of installed channels may display
empty channel numbers. You can
rename, reorder or uninstall these
channels.
Access DVB-C or DVB-T channels
If you have installed both DVB-C and DVB-T
channels, you have to switch to the
respective network to watch channels on
that network.
1. While watching TV, press .
2. Select [Setup] > [Channel settings].
3. Select [Channel installation] > [Antenna
or Cable DVB].
4. Select one of the following settings:
[Antenna (DVB-T)]: Access free-to-air
antenna or digital DVB-T channels
[Cable]: Access cable or digital DVB-C
channels.
3. Press OK to confirm your choice.
4. Press to exit.
The TV switches to the selected channel list.
Access DVB-S channels (for certain models
only)
If your satellite is connected to the SAT
connector, you can receive satellite channels.
Press > [Watch satellite] to watch
satellite channels.
Install analogue channels
NonPublish
This section describes how to search and
store analogue TV channels manually.
Step 1: Select your system
Note: Skip this step if your system settings
are correct.
1. While watching TV, press .
2. Select [Setup] > [Channel settings] >
[Channel installation] > [Analogue: Manual
installation] > [System], then press OK.
3. Select the system for your country or
region, then press OK.
Step 2: Search and store new TV channels
1. In the [Analogue: Manual installation]
menu, select [Find channel], then press OK.
2. Press:
The Navigation buttons or Numeric
buttons to manually enter the channel
frequency.
The Navigation buttons to select
[Search]. Press OK to automatically
search for the next channel.
3. When the correct channel frequency is
entered, select [Done], then press OK.
4. Select [Store current channel] to store
the fine tuned channel as the current channel
number, or select [Store as new channel] to
store it as a new channel number.
Install digital channels
NonPublish
You can reposition your antenna to improve
the reception. You need to know the
correct frequency to tune. For best results,
contact the service provider or get a
professional installer.
1. Press .
2. Select [Setup] > [Channel settings] >
[Channel installation] > [Digital: Reception
test] > [Search], then press OK.
3. Press the Numeric buttons to enter the
channel frequency.
4. Select [Search], then press OK.
5. When the correct channel is located,
select [Store], then press OK.
6. Press to exit.
Notes
If the reception is poor, reposition your
antenna and repeat the procedure.
If you receive the channel with DVB-C,
the options [Symbol rate mode] and
[Symbol rate] are available.
In [Symbol rate mode], select
[Automatic] unless your cable provider
supplies you with a specific symbol rate
value.
Install satellite channels
(For certain models only)
If your satellite is connected to the SAT
connector, you can receive satellite channels.
1. While watching TV, press .
2. Select [Setup] > [Search for satellite] >
[Reinstall channels].
3. Follow the on-screen instructions to
complete the installation of satellite channels.
4. Once complete, select [Finish], and then
press OK.
Downloaded From TV-Manual.com Manuals