Filter
Top Products
EN 54
Connect
1. Switch on the router and switch on its
DHCP setting.
2. With the ethernet cable, connect the
router to the TV.
Alternatively, you can also connect the
router to the TV wirelessly, through a
wireless USB adaptor (not included). See
Connect your TV > Computers and the
Internet > Wireless LAN ready (Page 54).
3. Press , select [Setup] > [Connect to
network], then press OK.
4. Follow the onscreen instructions to install
the network.
5. Wait for the TV to find the network
connection.
6. If you are prompted, agree to the End
User License Agreement.
Wireless LAN ready
This TV is Wireless LAN ready. With the
Wireless LAN adapter PTA01 accessory
(sold separately), you can connect the TV to
your home network wirelessly. You can
enjoy the best of the web from Net TV
services, and sharing of content between
your devices connected to the home
network using Wi-Fi MediaConnect or
DLNA, seamlessly and hassle free.
Note:
The wireless network operates in the
same 2.4GHz frequency spectrum as
common household devices, such as
Dect phones, microwave ovens or
Bluetooth devices, which can cause Wi-
Fi interferences. Move these devices
away from the TV with the connected
Wireless USB adapter.
You should turn off any unused
network equipment in the home
network as this increases network
traffic.
Reception quality is dependent on the
location of the wireless router, as well
as the quality of services provided by
the local Internet Service Provider.
When playing video over your wireless
home network, we recommend that
you use an IEEE 802.11 N router. The
connection speed may differ according
to the operating environment of your
wireless home network.
Make your TV wireless
1. Switch on your wireless network router.
2. Insert the USB adapter PTA01 into the
USB connection at the side of the TV. The
wireless installation starts automatically.
3. Follow the on screen instructions.
WPS - Wi-Fi Protected Setup
If your router supports WPS (Wi-Fi
Protected Setup), press the WPS button on
the router. Return to the TV in 2 minutes,
select [WPS] and press OK. The TV
connects to your network. This takes about
2 minutes. Complete the installation.
Most new wireless routers have the WPS
system and carry the WPS logo. The WPS
system uses WPA security encryption and
cannot be combined with devices on your
network that use the WEP security
encryption. If you still need this WEP device
in your network, install with [Scan] >
[Custom].
Downloaded From TV-Manual.com Manuals