Filter
Top Products
EN-25
EN
9 Install system devices
Caution C
Before installing a System SmartCard or
System Box, disconnect TV from mains.
9�1 System Smartcard
Note D
Not applicable for 22 inch models.
Insert the SmartCard into the SmartCard 1.
slot on the back of the TV.
Connect the cables as instructed by the 2.
system provider.
Switch on the TV.3.
9�2 System Box
Insert the RJ12 cable of the System box to 1.
the DATA 1 connector on the back of the
TV.
System Box
to DATA 1
Connect the cables as instructed by the 2.
system provider.
Switch on the TV.3.
Set 9�3 communication source
The default setting for COMMUNICATION
in the SETUP menu is OFF
. If a SystemCard
or System Box is used with this TV, then you
must set to the correct communication link.
Enter
1. SETUP menu.
Press
2. ï to select COMMUNICATION.
Press
3. Æ to enter COMMUNICATION.
Press
4. Æ to select the correct link.
COMMUNICATION
COMMUNICATION SP - 12C
STORE >
ENABLE CARD SLOT YES
DCM TYPE GENERIC
Press 5. ï to select ENABLE CARD
SLOT.
Press
6. Æ to select YES.
Press
7. Î to select STORE.
Press
8. Æ to confirm.